Hobbywing Xrotor Micro 60A 6S 4in1 ESC BLHeli-32 DShot1200 FC Combo

XRotor Flight Controller F4 G3 & Micro 60A 4in1 BLHeli-32 DShot1200 Combo Set

FC F4 G3 Super hardware and running speed
Super hardware, fast running speed integrates with STM32F405 MCU which features powerful computing capacity & super operating speed and high sensitivity ICM20602 6-axis motion sensor. It can run PID cyclic frequency and gyro refresh frequency at 32KHz. Integrated OSD chip can set OSD parameters on FMU parameter software and remote controller. Convenient and simple. Integrated OSD extended slot can record and save more flight log which is convenient for user to adjust aircraft based on flight data.

Highly Integrated Micro 60A 4in1 ESC
With a similar size of a FC, the 4IN1 ESC includes 4 high performance 60A BLHeli_32 DShot1200 ESCs, a 5V BEC which can provide power for devices (i.e. FC), and a voltmeter which allows FC to monitor the amp & volt in real time. Two ways for connecting the ESC to a FC: 1) connecting via soft cables, 2) soldering via solder tabs are provided for selection. And the shock-absorbing design of mounting holes effectively reduces the external vibration's impact on high-sensitivity components and provides great shock-absorbing protection to upper devices (i.e. FC). This ESC is designed for FPV racing.


XRotor Flight Controller F4 G3 Specs:

• Compatible with (Multirotors): Quadcopter
• Firmware: OMNIBUSF4SD
• FC Programming: Supported
• Programming via: Betaflight/Cleanflight-configurator or Others
• Compatible with (Modes): PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, DShot1200, Proshot1000 and etc.
• Compatible with (Transmitters): PPM, Spektrum, SBUS, SUMD, SUMH, XBUS, IBUS, JETIEXBUS, CRSF, SRXL, and etc.
• OSD: Built-in
• Voltage Monitoring: Supported
• Current Monitoring: Supported
• External Buzzer: Supported
• LED Control: Supported
• BEC: 12V @ 2A
• USB Port: MicroUSB

Size & Weight:

• Size: 36x36mm
• Weight: 6g

Applications:

• 130-300mm FPVs

XRotor Micro 60A 4in1 BLHeli-32 DShot1200 Specifications:

• Continuous/Peak Current: 60Ax4/ 80Ax4
• Input Voltage: 3-6S LiPo
• BEC output: 5V/0.6A

Wires & Connectors:

• Input Wires: 12AWG/130mm
• Output Wires: No wires but solder tabs
• Input Connectors: XT60 (w/ Wires Soldered on)
• Output Connectors: No

(Note: All the wire length above is the original length not the length you see from the outside.)

Programming etc:

• Firmware: Hobbywing_XRotor_BLHeli-32 Firmware
• ESC Programming: BLHeliSuite32
• Stick Programming: Supported
• DEO: Supported
• Throttle Range Calibration: Supported
• Oneshot125 Mode: Supported
• Oneshot42 Mode: Supported
• MultiShot Mode: Supported
• DShot150/300/600/1200: Supported
• Timing: Supported
• Motor Rotation: Supported

Size & Weight:

• Size: 52x42x6.6mm
• Weight: 15g
• Applications: 130-300mm FPVs